// Overview
The Core Reinforcement Product
Epoxy-Coated TMT is the same deformed reinforcing bar used in every reinforced concrete structure, produced to full IS 1786 mechanical specification, with a continuous Fusion-Bonded Epoxy film applied over the entire bar surface — ribs, deformations, and cut ends included.
Because the coating is applied before the bar reaches site, every length behaves identically: same yield strength, same elongation, same bond performance with concrete, but with a chloride and moisture barrier that plain TMT does not have. It is specified wherever the design life of a structure depends on the reinforcement outlasting the concrete cover around it.
- Zero change to mechanical properties — full IS 1786 structural compliance retained
- Coating covers ribs and deformations, not just the flat bar surface
- Supplied cut-to-length or in standard 12 m bundles, tagged by heat number
- Compatible with standard tie wire, couplers, and mechanical splicing systems
- Available in Fe 415, Fe 500, Fe 500D, and Fe 550 grades
Specification Snapshot
Diameter range
8, 10, 12, 16, 20, 25, 28, 32 mm
Grades
Fe 415 / Fe 500 / Fe 500D / Fe 550
Coating standard
IS 13620 (FBE)
Coating thickness
175–300 microns
Base bar standard
IS 1786
Supply form
12 m straight lengths or cut-to-length
Request This Product